Caution / Notice / Hint
WARNING: This page is about a different car, the 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly adjustment are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Perform steering sensor zero point calibration | Lane Control System (for Gasoline Model) | Refer to INITIALIZATION [06/2018 - 09/2022] |
| Pre-collision System (for Gasoline Model) | |||
| Lighting System (w/ AFS) (EXT) | |||
| Replacement of ECM | Vehicle Identification Number (VIN) registration | MIL comes on | Refer to REGISTRATION [01/2019 - 11/2022] |
| ECU communication ID registration (Immobiliser system) | Engine start function | Refer to REGISTRATION [01/2019 - 09/2019] , or refer to REGISTRATION [09/2019 - 04/2020] , or refer to REGISTRATION [04/2020 - 09/2022] | |
| Replacement of ECM*1 | Code registration (Immobiliser system) | Engine start | Refer to REGISTRATION [01/2019 - 09/2019] , or refer to REGISTRATION [09/2019 - 04/2020] , or refer to REGISTRATION [04/2020 - 09/2022] |
*1: w/o Smart Key System
NOTE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System and Audio and Visual System (for Gasoline Model))