LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2024 >> Corolla LE >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Manual Transaxle System (EC65) - Service Information (1 Of 2)) >> Manual Transaxle Assembly >> Removal [09/2022 - 11/2022] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different car, the 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during manual transaxle assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of ECM Vehicle Identification Number (VIN) registration MIL comes on Refer to REGISTRATION [01/2019 - 11/2022]
ECU communication ID registration (Immobiliser system) Engine start function Refer to REGISTRATION [09/2022 - 11/2022]
Gas leak from exhaust system is repaired Inspection after repair
  • Poor idle, etc.
  • Engine start function, etc.
 Refer to INITIALIZATION [01/2019 - 11/2022]
Replacement of ECM*1 Code registration (Immobiliser system)
  • Engine start
  • Telematics System
 Refer to REGISTRATION [09/2022 - 11/2022]
Front wheel alignment adjustment
  • Perform "Reset Memory"
  • Perform acceleration sensor zero point calibration and store system information memorization
  • VSC is disabled or malfunctions
  • DTCs are output
  • Slip indicator light illuminates
  • ABS warning light illuminates
 w/ Electric Parking Brake System:
Refer to UTILITY [09/2022 - 11/2022]
w/o Electric Parking Brake System:
Refer to UTILITY [09/2022 - 11/2022]

*1: w/o Smart Key System

WARNING:
  • To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
    GTY563662Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  • The manual transaxle assembly is very heavy. Be sure to follow the procedure described in the repair information, or the transmission jack may suddenly drop.
    GTY559497Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    *a An Object Exceeding Weight Limit of Transmission Jack
  • If work is not performed according to the procedures described in the repair information, there is a danger that the transmission jack could drop and components could fall down.
NOTE:

When the manual transaxle assembly is removed, be sure to use a new clutch release cylinder with bearing assembly and new installation bolts. Removal of the manual transaxle assembly allows the compressed clutch release cylinder with bearing assembly to return to its original position. Dust from the moving section may damage the seal of the clutch release cylinder with bearing assembly, possibly causing clutch fluid leaks.

HINT: 

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

LEARNING COMPLETES WHEN VEHICLE IS DRIVEN

Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedure Link
Pre-collision System (for TMMMS Made) Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. Refer to INITIALIZATION [09/2022 - 11/2022]
Lane Tracing Assist System (for TMMMS Made)
Lane Departure Alert System (for TMMMS Made)
scientia non olet · About LEMON Manuals