LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2024 >> Corolla LE >> Repair and Diagnosis >> External Pages >> Different car >> Section 318 (Manual Transaxle System - Service Information (1 Of 2)) >> Neutral Position Switch >> Removal [11/2022 - 09/2024] >> Procedure

Removal [11/2022 - 09/2024]: Procedure

WARNING: This page is about a different car, the 2025 Toyota GR Corolla, 2024 Toyota GR Corolla, and 2023 Toyota GR Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 9

  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH (w/ Engine Under Cover Air Guide) 

    Refer to PROCEDURE - Step 10

  3. REMOVE NO. 3 ENGINE UNDER COVER AIR GUIDE (w/ Engine Under Cover Air Guide) 

    Refer to PROCEDURE - Step 17

  4. REMOVE REAR ENGINE UNDER COVER LH 

    Refer to PROCEDURE - Step 18

  5. REMOVE NEUTRAL POSITION SWITCH 
    1. Disconnect the neutral position switch connector.
      GTY1109675Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using SST, remove the neutral position switch and gasket from the manual transaxle assembly.
      • SST: 09817-16011 
      GTY1113539Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals