DTC P0116: Engine Coolant Temperature Circuit Range / Performance [03/2019 - 11/2022]: Procedure
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs.
Powertrain > Engine and ECT > Trouble Codes
Result
Result Proceed to DTC P0116 is output A DTC P0116 and other DTCs are output B HINT:
If any DTCs and other than P0116 are output, troubleshoot those DTCs first.
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [03/2019 - 04/2020] , or refer to DIAGNOSTIC TROUBLE CODE CHART [04/2020 - 09/2022] , or refer to DIAGNOSTIC TROUBLE CODE CHART [09/2022 - 11/2022]
Result:
A
See step 2
- INSPECT THERMOSTAT
- Inspect the thermostat (thermostat opening temperature).
Refer to INSPECTION [01/2019 - 11/2022]
HINT:
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Refer to INITIALIZATION [01/2019 - 11/2022]
Result
Proceed to OK NG
Result:
OK
REPLACE ENGINE COOLANT TEMPERATURE SENSOR. Refer to REMOVAL [03/2019 - 09/2022] , or refer to REMOVAL [09/2022 - 11/2022]
Result:
NG
REPLACE THERMOSTAT. Refer to REMOVAL [01/2019 - 11/2022]
- Inspect the thermostat (thermostat opening temperature).