DTC P0500: Vehicle Speed Sensor [09/2022 - 11/2022]: Procedure
WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, 2020 Toyota Corolla, and 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- READ VALUE USING TECHSTREAM (VEHICLE SPEED)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Data List / Vehicle Speed.
Powertrain > Engine and ECT > Data List
Tester Display Vehicle Speed - Drive the vehicle.
- Read the value displayed on the Techstream.
Result
Result Proceed to Values displayed on Techstream and speedometer display not equal A Values displayed on Techstream and speedometer display equal B
Result:
B
CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [01/2019 - 11/2022]
Result:
A
See step 2
- CHECK METER / GAUGE SYSTEM
- Check the circuits that send vehicle speed signals to this system in the combination meter system.
Refer to Speed Signal Circuit [09/2022 - 11/2022]
Result
Proceed to NEXT
Result:
NEXT
See step 3
- Check the circuits that send vehicle speed signals to this system in the combination meter system.
- CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)
- Disconnect the combination meter assembly connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition E43-6 (+S) - A40-44 (SPD) Always Below 1 Ω Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [09/2022 - 11/2022]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR