Inspection [01/2019 - 11/2022]: Procedure
WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, 2020 Toyota Corolla, and 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT IGNITION OR STARTER SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Ignition or Starter Switch Assembly)*b LOCK *c ACC *d ON *e START Standard Resistance
Tester Connection Condition Specified Condition Between all terminals LOCK 10 kΩ or higher 6 (ACC) - 7 (AM1) ACC Below 1 Ω 6 (ACC) - 7 (AM1) - 8 (IG1) ON Below 1 Ω 5 (ST1) - 7 (AM1) - 8 (IG1) START Below 1 Ω If the result is not as specified, replace the ignition or starter switch assembly.
- Measure the resistance according to the value(s) in the table below.