Voice Guidance Circuit between Radio Receiver and Stereo Component Amplifier [06/2018 - 11/2022]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Toyota GR Corolla, 2023 Toyota Corolla, 2022 Toyota Corolla, 2021 Toyota Corolla, and 2020 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
- Disconnect the I71 radio and display receiver assembly connector.
- Disconnect the I68 stereo component amplifier assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester connection Condition Specified condition I71-3 (RL+) - I68-15 (II1+) Always Below 1 Ω I71-8 (RL-) - I68-14 (II1-) Always Below 1 Ω I68-18 (SLD1) - Body ground Always 10 kΩ or higher I71-3 (RL+) or I68-15 (II1+) - Body ground Always 10 kΩ or higher I71-8 (RL-) or I68-14 (II1-) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [06/2018 - 01/2019] , or refer to PROBLEM SYMPTOMS TABLE [01/2019 - 03/2019] , or refer to PROBLEM SYMPTOMS TABLE [03/2019 - 09/2019] , or refer to PROBLEM SYMPTOMS TABLE [09/2019 - 04/2020] , or refer to PROBLEM SYMPTOMS TABLE [04/2020 - 09/2022] , or refer to PROBLEM SYMPTOMS TABLE [09/2022 - 11/2022]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR