Radio Receiver Power Source Circuit [06/2018 - 03/2019]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Toyota GR Corolla, 2023 Toyota Corolla, 2022 Toyota Corolla, 2021 Toyota Corolla, and 2020 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE)
- Disconnect the I55 and I56 radio and display receiver assembly connectors.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition I55-1 (GND1) - Body ground Always Below 1 Ω - Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition I55-4 (+B1) - I55-1 (GND1) Always 11 to 14 V I55-15 (ACC1) - I55-1 (GND1) Engine switch on (ACC) 11 to 14 V I56-19 (IG) - I55-1 (GND1) Engine switch on (IG) 11 to 14 V Result
Proceed to OK NG
Result:
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [06/2018 - 01/2019] , or refer to PROBLEM SYMPTOMS TABLE [01/2019 - 03/2019]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR