Emergency Call Switch Illumination Circuit [09/2019 - 04/2020]: Procedure

1. Disconnect the I72 DCM (telematics transceiver) connector.
2. Disconnect the T6 map light assembly (manual (SOS) switch) connector.
3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   T6-20 (RRID) - Body Ground	Engine switch on (IG)	11 to 14 V

4. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I72-3 (SIG-) - T6-12 (GND3)	Always	Below 1 Ω
   I72-3 (SIG-) or T6-12 (GND3) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

1. Remove the map light assembly (manual (SOS) switch).

   Refer to REMOVAL [01/2019 - 09/2022]

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Component without harness connected (Map Light Assembly (Manual (SOS) Switch))

2. Apply battery voltage to the connector and check that the map light assembly (manual (SOS) switch) comes on.

   OK

   Measurement Condition	Condition	Specified Condition
   Battery positive (+) → T6-20 (RRID) Battery negative (-) → T6-12 (GND3)	Always	Manual (SOS) switch illumination cones on

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH). Refer to  REMOVAL [01/2019 - 09/2022] 

Result: 

OK 

See step  3

1. Replace the DCM (telematics transceiver) with a new one.

   Refer to REMOVAL [09/2019 - 04/2020]

   NOTE:

   • The engine switch must be off.
   • Do not exchange the DCM (telematics transceiver) with one from another vehicle.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM DCM ACTIVATION. Refer to  DCM ACTIVATION [09/2019 - 04/2020]