LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2024 >> Corolla LE >> Repair and Diagnosis >> External Pages >> Different car >> Section 166 (Pre-Collision System (HEV) - Diagnostic Codes) >> PRE-COLLISION SYSTEM (for HV Model) >> DTC U0300-51: Internal Control Module Software Incompatibility Not Programmed [04/2020 - 09/2022] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, and 2020 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.
  • If the forward recognition camera has been replaced with a new one, forward recognition camera adjustment must be performed.

    HINT: 

    Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.

    One Time Recognition: Refer to ADJUSTMENT (ONE TIME RECOGNITION) [01/2019 - 09/2022]

    Sequential Recognition: Refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [01/2019 - 09/2022]

scientia non olet · About LEMON Manuals