LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2024 >> Corolla LE >> Repair and Diagnosis >> External Pages >> Different car >> Section 161 (Engine Mechanical System - Service Information (1 Of 3)) >> Cylinder Head Gasket >> Removal [09/2022 - 11/2022] >> Procedure

Removal [09/2022 - 11/2022]: Procedure

WARNING: This page is about a different car, the 2025 Toyota GR Corolla, 2024 Toyota GR Corolla, and 2023 Toyota GR Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE INTAKE CAMSHAFT SUB-ASSEMBLY 

    See step  36

  2. REMOVE NO. 1 CAMSHAFT BEARING CAP 

    Refer to PROCEDURE - Step 40

  3. REMOVE NO. 5 CAMSHAFT BEARING CAP 

    Refer to PROCEDURE - Step 41

  4. REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 42

  5. REMOVE VALVE LASH ADJUSTER ASSEMBLY 

    Refer to PROCEDURE - Step 43

  6. REMOVE VALVE STEM CAP 

    Refer to PROCEDURE - Step 44

  7. REMOVE CYLINDER HEAD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 45

  8. REMOVE CYLINDER HEAD GASKET 
    1. Remove the cylinder head gasket from the cylinder block sub-assembly.
      GTY1020407Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. INSPECT CYLINDER HEAD SET BOLT 

    Refer to PROCEDURE - Step 12

  10. INSPECT CYLINDER HEAD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1

scientia non olet · About LEMON Manuals