Utility [06/2018 - 09/2022]
- If the forward recognition camera has been replaced with a new one or the windshield glass has been removed and installed, it is necessary to perform forward recognition camera adjustment.
HINT:
Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.
One Time Recognition: Refer to ADJUSTMENT (ONE TIME RECOGNITION) [06/2018 - 01/2019] , or refer to ADJUSTMENT (ONE TIME RECOGNITION) [01/2019 - 09/2022]
Sequential Recognition: Refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [06/2018 - 01/2019] , or refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [01/2019 - 09/2022]
- When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the forward recognition camera may not be able to be installed due to a missing bracket or the front camera system may not operate properly due to a difference in the transmissivity or black ceramic border.
- Recognition Camera/Target Position Memory
HINT:
Recognition Camera/Target Position Memory is used to enter required information into the forward recognition camera.
- Perform Recognition Camera/Target Position Memory according to the display on the Techstream.
Chassis > Front Recognition Camera > Utility
Tester Display Recognition Camera/Target Position Memory HINT:
For forward recognition camera adjustment procedures.
Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.
One Time Recognition: Refer to ADJUSTMENT (ONE TIME RECOGNITION) [06/2018 - 01/2019] , or refer to ADJUSTMENT (ONE TIME RECOGNITION) [01/2019 - 09/2022]
Sequential Recognition: Refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [06/2018 - 01/2019] , or refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [01/2019 - 09/2022]
- Perform Recognition Camera/Target Position Memory according to the display on the Techstream.
- Recognition Camera Axis Adjust
HINT:
Recognition Camera Axis Adjust is used to calibrate the internal data of the forward recognition camera to enhance its recognition accuracy.
- Perform Recognition Camera Axis Adjust according to the display on the Techstream.
Type A
Chassis > Front Recognition Camera > Utility
Tester Display Recognition Camera Axis Adjust Type B
Chassis > Front Recognition Camera > Utility
Tester Display Recognition Camera Axis Adjust HINT:
For forward recognition camera adjustment procedures.
Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.
One Time Recognition: Refer to ADJUSTMENT (ONE TIME RECOGNITION) [06/2018 - 01/2019] , or refer to ADJUSTMENT (ONE TIME RECOGNITION) [01/2019 - 09/2022]
Sequential Recognition: Refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [06/2018 - 01/2019] , or refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [01/2019 - 09/2022]
- Perform Recognition Camera Axis Adjust according to the display on the Techstream.
- PCS Image Information Clear
HINT:
PCS Image Information Clear is used to clear the PCS Image Information data.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Chassis / front recognition camera / Utility / PCS Image Information Clear.
- Perform PCS Image Information Clear according to the display on the Techstream.
Chassis > Front Recognition Camera > Utility
Tester Display PCS Image Information Clear
- PCS Image Record Setting
HINT:
PCS Image Record Setting is used to activate/deactivate the PCS image recording function.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Chassis / front recognition camera / Utility / PCS Image Record Setting.
- Perform PCS Image Record Setting according to the display on the Techstream.
Chassis > Front Recognition Camera > Utility
Tester Display PCS Image Record Setting