Inspection [09/2024 - ]: Procedure
WARNING: This page is about a different car, the 2025 Toyota GR Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
- No. 1 transmission shift switch assembly:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(No. 1 Transmission Shift Switch Assembly)Standard Resistance
Tester Connection Condition Specified Condition 1 (SDN) - 2 (ECC) "-" (Down shift) shift paddle switch operated and held Below 2.5 Ω "-" (Down shift) shift paddle switch not operated 1 MΩ or higher 1 (SDN) - 3 (ECC1) "-" (Down shift) shift paddle switch operated and held Below 2.5 Ω "-" (Down shift) shift paddle switch not operated 1 MΩ or higher If the result is not as specified, replace the No. 1 transmission shift switch assembly.
- Measure the resistance according to the value(s) in the table below.
- No. 2 transmission shift switch assembly:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(No. 2 Transmission Shift Switch Assembly)Standard Resistance
Tester Connection Condition Specified Condition 1 (SUP) - 2 (ECC) "+" (Up shift) shift paddle switch operated and held Below 2.5 Ω "+" (Up shift) shift paddle switch not operated 1 MΩ or higher If the result is not as specified, replace the No. 2 transmission shift switch assembly.
- Measure the resistance according to the value(s) in the table below.
- No. 1 transmission shift switch assembly: