Inspection [09/2024 - ]: Procedure
WARNING: This page is about a different car, the 2025 Toyota GR Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT COMBINATION SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Combination Switch Assembly)"DRIVE +" Side "DRIVE -" Side Standard Resistance
Tester Connection Condition Specified Condition 7 (SEL) - 5 (E) Pushed and held at "DRIVE +" side Below 50 Ω Released (neutral position) 10 kΩ or higher 6 (E) - 5 (E) Pushed and held at "DRIVE -" side Below 50 Ω Released (neutral position) 10 kΩ or higher If the result is not as specified, replace the combination switch assembly.
- Apply battery voltage between the terminals of the switch and check the illumination condition of the combination switch assembly.
Standard
Measurement Condition Specified Condition Battery positive (+) → 4 (ILL+)
Battery negative (-) → 1 (ILL-)Illuminates If the result is not as specified, replace combination switch assembly.
*a Component without harness connected
(Combination Switch Assembly)
- Measure the resistance according to the value(s) in the table below.