On-Vehicle Inspection [01/2019 - 11/2022]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, 2020 Toyota Corolla, and 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

SECURE VEHICLE

Fully apply the parking brake and chock a wheel.

WARNING:

Make sure to apply the parking brake and chock a wheel before performing this procedure.

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

INSPECT SHIFT LEVER POSITION
1. When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, check that the shift lever moves smoothly and correctly into position.
2. Start the engine and check that the vehicle moves forward when the shift lever is moved from N to D and moves rearward when the shift lever is moved to R.
  If the operation is not as specified, inspect or adjust the park/neutral position switch assembly or floor shift transmission control select cable.
INSPECT SHIFT LOCK OPERATION
1. Move the shift lever to P.
2. Turn the ignition switch off.
3. Check that the shift lever cannot be moved from P to any other position.
4. Turn the ignition switch to ON, depress the brake pedal, and check that the shift lever can be moved to another position.
  If the operation is not as specified, inspect the shift lock control unit assembly.
  
  Refer to INSPECTION [01/2019 - 11/2022]
INSPECT SHIFT LOCK RELEASE BUTTON OPERATION
1. Move the shift lever to P.
2. Turn the ignition switch off.
3. Remove the shift lock release button cover.
  See step 2
4. Press the shift lock release button and check that the shift lever can be moved from P to any other position.
INSPECT KEY INTERLOCK OPERATION (w/o Smart Entry and Start System)
1. Turn the ignition switch to ON.
2. Depress the brake pedal and move the shift lever to any position other than P.
3. Check that the ignition key cannot be turned to LOCK.
4. Move the shift lever to P, turn the ignition key to LOCK and check that the ignition key can be removed.
  If the operation is not as specified, inspect the shift lock control unit assembly.
  
  Refer to INSPECTION [01/2019 - 11/2022]