LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2024 >> Corolla LE >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (Automatic Transaxle System (K313) - Service Information) >> Pattern Select Switch >> Inspection [01/2019 - 11/2022] >> Procedure

Inspection [01/2019 - 11/2022]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, 2020 Toyota Corolla, and 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT COMBINATION SWITCH ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      6 (MSW1) - 5 (E) Pressed Below 50 Ω
      Not pressed 10 kΩ or higher

      If the result is not as specified, replace the combination switch assembly.

      GTY850851Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Combination Switch Assembly)
    2. Apply battery voltage between the terminals of the switch and check the illumination condition of the combination switch assembly.

      Standard

      Measurement Condition Specified Condition
      Battery positive (+) → 4 (ILL+)
      Battery negative (-) → 1 (ILL-)      		 Illuminates

      If the result is not as specified, replace the combination switch assembly.

      GTY850850Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Combination Switch Assembly)
scientia non olet · About LEMON Manuals