Inspection [01/2019 - 11/2022]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, 2020 Toyota Corolla, and 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

Measure the resistance according to the value(s) in the table below.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Component without harness connected (Park/Neutral Position Switch Assembly)

Standard Resistance

Tester Connection	Condition	Specified Condition
4 (B) - 9 (L)	Shift lever in P or N	Below 1 Ω
4 (B) - 9 (L)	Shift lever not in P or N	10 kΩ or higher
1 (RB) - 3 (PL)	Shift lever in P	Below 1 Ω
1 (RB) - 3 (PL)	Shift lever not in P	10 kΩ or higher
1 (RB) - 2 (RL)	Shift lever in R	Below 1 Ω
1 (RB) - 2 (RL)	Shift lever not in R	10 kΩ or higher
1 (RB) - 8 (NL)	Shift lever in N	Below 1 Ω
1 (RB) - 8 (NL)	Shift lever not in N	10 kΩ or higher
1 (RB) - 7 (DL)	Shift lever in D, M, "+" or "-"	Below 1 Ω
1 (RB) - 7 (DL)	Shift lever not in D, M, "+" or "-"	10 kΩ or higher

If the result is not as specified, replace the park/neutral position switch assembly.