DTC B1585: USB Device Malfunction [03/2019 - 11/2022]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Toyota GR Corolla, 2023 Toyota Corolla, 2022 Toyota Corolla, 2021 Toyota Corolla, and 2020 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- REPLACE USB DEVICE OR "iPod"
- Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
- Turn the ignition switch off.
HINT:
When this DTC has been stored, it is necessary to turn the ignition switch off to make it possible for the vehicle to recognize a new device when it is connected.
- Turn the ignition switch to ACC.
- Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
HINT:
- If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
- Refer to System Description for compatible formats and versions.
Refer to SYSTEM DESCRIPTION [01/2019 - 09/2019] , or refer to SYSTEM DESCRIPTION [09/2019 - 04/2020] , or refer to SYSTEM DESCRIPTION [04/2020 - 11/2022]
Result
Proceed to NEXT
Result:
NEXT
See step 2
- CHECK DTC
- Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs
- Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble Codes
OK
No DTCs are output.
Result
Proceed to OK NG
Result:
OK
END (USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE)
Result:
NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY. Refer to REMOVAL [03/2019 - 09/2022] , or refer to REMOVAL [09/2022 - 11/2022]
- Clear the DTCs.