DTC P0013-13: Camshaft Position "B" - Actuator Bank 1 Circuit Open [09/2022 - ]: Procedure

1. Record the Freeze Frame Data.

   Powertrain > Engine > Trouble Codes 

2. Clear the DTCs.

   Powertrain > Engine > Clear DTCs 

3. Turn the ignition switch off and wait for at least 30 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Start the engine.
2. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   P0013-13 is output	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS 

Refer to CHECK FOR INTERMITTENT PROBLEMS [09/2022 - ]

Result: 

B 

See step  3

Refer to INSPECTION [09/2022 - ]

Result

Result: 

NG 

REPLACE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY 

Refer to REMOVAL [09/2022 - ]

Result: 

OK 

See step  4

1. Disconnect the cam timing oil control solenoid assembly (for exhaust camshaft) connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C18-1(+) - C142-25 (OE1+)	Always	Below 1 Ω
   C18-2(-) - C142-26 (OE1-)	Always	Below 1 Ω
   C18-1(+) or C142-25 (OE1+) - Body ground and other terminals	Always	10 kΩ or higher
   C18-2(-) or C142-26 (OE1-) - Body ground and other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM 

Refer to REMOVAL [09/2022 - 11/2022] , or refer to REMOVAL [11/2022 - 09/2024] , or refer to REMOVAL [09/2024 - ]

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR