Engine Oil Pressure Switch Circuit [11/2022 - ]: Procedure

Refer to INSPECTION [01/2019 - ]

Result

Result: 

NG 

REPLACE ENGINE OIL PRESSURE SWITCH ASSEMBLY 

Refer to REMOVAL [01/2019 - ]

Result: 

OK 

See step  2

1. Disconnect the I5 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C39-1 - I5-9 (S)	Always	Below 1 Ω
   C39-1 or I5-9 (S) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY 

Refer to REMOVAL [11/2022 - 09/2024] , or refer to REMOVAL [09/2024 - ]

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR