DTC P16B0-9F: Actuator Cut Circuit Stuck Off [11/2018 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs.

   Powertrain > Transmission > Clear DTCs 

   HINT: 

   Write down the currently output DTCs before clearing them.

5. Turn the ignition switch off.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
2. Connect the cable to the negative (-) battery terminal.
3. Turn the ignition switch to ON and wait for 1 minute or more.
4. Turn the ignition switch off and wait for 2 minutes or more.

   HINT: 

   This DTC is detected after the ignition switch is turned off.

5. Connect the Techstream to the DLC3.
6. Turn the ignition switch to ON.
7. Turn the Techstream on.
8. Enter the following menus: Powertrain / Transmission / Trouble Codes.

   Powertrain > Transmission > Trouble Codes 

9. Read the DTCs using the Techstream.

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC P16B0-9F is output	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ] 

Result: 

B 

See step  3

1. Replace the ECM.

   Refer to REMOVAL [11/2018 - 08/2020] , or refer to REMOVAL [08/2020 - 10/2022] , or refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM REGISTRATION. Refer to  REGISTRATION [11/2018 - ]