Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL
| The monitor will run whenever the following DTCs are not stored | None |
| Solenoid current cut status | Not cut |
| Ignition switch | ON |
| Starter | OFF |
| Battery voltage | 10.5 V or higher |
CONDITION (A)
| Battery voltage | 8 V or higher and below 12.499 V |
| Target current (0.1 seconds or more) | 0.8 A or less |
CONDITION (B)
| Battery voltage | 12.5 V or higher and below 16 V |
| Target current (0 seconds or more) | 1 A or less |