Caution / Notice / Hint
WARNING: This page is about a different car, the 2022 Toyota RAV4, 2021 Toyota RAV4, 2020 Toyota RAV4, and 2019 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly or navigation ECU may not operate normally.
- Inspect the fuses for circuits related to this system before performing the following procedure.
- Before replacing the DCM (telematics transceiver), refer to Registration.
for Gasoline Model: Refer to REGISTRATION [08/2020 - 12/2021] , or refer to REGISTRATION [12/2021 - ]
for HV Model: Refer to REGISTRATION [10/2019 - 12/2021] , or refer to REGISTRATION [12/2021 - ]
- When replacing the DCM (telematics transceiver), make sure to replace it with a new one.
HINT:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Refer to PRECAUTION [10/2019 - 10/2022]