Typical Enabling Conditions
WARNING: This page is about a different car, the 2020 Toyota RAV4 and 2019 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
CASE 1
| Monitor runs whenever the following DTCs are not stored | None |
| Both of the following conditions are met | - |
| Starter | After off to on timing |
| Minimum battery voltage while starter on | Less than 11 V |
CASE 2
| All of the following conditions are met | - |
| Engine speed | 600 rpm or higher |
| Exhaust camshaft position sensor range check fail (P0367, P0368) | Not detected |
| Ignition switch | ON |
| Starter | Off |
| Battery voltage | 8 V or higher |
| Exhaust camshaft position sensor voltage | 0.3 to 4.7 V |
| Idling stop control* | Not operating |
*: w/ Stop and Start System