Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear stabilizer bar removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Tires |
|
Tire Pressure Warning System | Refer to Procedures Necessary When Replacing Parts (for Tire Pressure Warning System) Refer to WORK PROCEDURE [12/2022 - 03/2023] |
| Rear television camera assembly optical axis (Back camera position setting)*3 | Parking Assist Monitor System | Refer to CALIBRATION [12/2022 - ] | |
| Parking assist ECU initialization*3 | Panoramic View Monitor System | Refer to CALIBRATION [12/2022 - ] | |
| Advanced Park | Refer to CALIBRATION [12/2022 - ] |
*1: Also necessary after performing a tire rotation.*2: It is not necessary to perform this procedure if the tire pressure warning valve and transmitters are installed to the same location.*3: The vehicle height changes because of suspension or tire replacement.
COMPONENTS (REMOVAL)
| Callout - Procedure | Part Name Code | ||||
|---|---|---|---|---|---|
| 1 | REAR FLOOR SIDE MEMBER COVER LH | 57628E | - | - | - |
| 2 | REAR FLOOR SIDE MEMBER COVER RH | 57627G | - | - | - |
| Callout - Procedure | Part Name Code | ||||
|---|---|---|---|---|---|
| 3 | REAR WHEEL | - | - | - | - |
| 4 | REAR STABILIZER BAR (for 2WD) | 48812 | See step 4 | - | - |
| 5 | REAR STABILIZER BAR (for AWD) | 48812 | See step 5 | - | - |
| 6 | REAR STABILIZER LINK ASSEMBLY LH | 48840A | See step 6 | - | - |
| 7 | REAR STABILIZER LINK ASSEMBLY RH | 48830D | - | - | - |
| *A | for 2WD | *B | for AWD |