Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear shock absorber assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Rear wheel alignment adjustment	Perform "Calibration"	DTCs are stored ABS warning light illuminates Brake system warning light (yellow indicator) illuminates Slip indicator light illuminates Electronically controlled brake system disabled or malfunctions	Refer to RESET MEMORY / CALIBRATION [12/2022 - ]
Tires	Initialization12 Tire Position Identification12	Tire Pressure Warning System	Refer to Procedures Necessary When Replacing Parts (for Tire Pressure Warning System) Refer to WORK PROCEDURE [03/2023 - ]
	Rear television camera assembly optical axis (Back camera position setting)*3	Parking Assist Monitor System	Refer to CALIBRATION [12/2022 - ]
	Parking assist ECU initialization*3	Panoramic View Monitor System	Refer to CALIBRATION [12/2022 - ]
	Parking assist ECU initialization*3	Advanced Park	Refer to CALIBRATION [12/2022 - ]
Suspension parts	Rear television camera assembly optical axis (Back camera position setting)	Parking Assist Monitor System	Refer to CALIBRATION [12/2022 - ]
	Parking assist ECU initialization	Panoramic View Monitor System	Refer to CALIBRATION [12/2022 - ]
	Parking assist ECU initialization	Advanced Park	Refer to CALIBRATION [12/2022 - ]

*1: Also necessary after performing a tire rotation.*2: It is not necessary to perform this procedure if the tire pressure warning valve and transmitters are installed to the same location.*3: The vehicle height changes because of suspension or tire replacement.

HINT:

Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.

COMPONENTS (REMOVAL)

Fig 1: Rear Shock Absorber Removal Components [03/2023 - ] (1 Of 3)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Callout - Procedure		Part Name Code
1	BATTERY BOX COVER	58219K	-	-	-
2	REAR FLOOR SIDE MEMBER COVER LH	57628E	-	-	-
3	REAR FLOOR SIDE MEMBER COVER RH	57627G	-	-	-

for PHEV Model

for HEV Model

Fig 2: Rear Shock Absorber Removal Components [03/2023 - ] (2 Of 3)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Callout - Procedure		Part Name Code
4	REAR WHEEL	-	-	-	-
5	LOOSEN REAR SHOCK ABSORBER ASSEMBLY	48540	See step 5	-	-
6	REAR STABILIZER LINK ASSEMBLY	48840A	-	-	-
7	SEPARATE REAR SHOCK ABSORBER ASSEMBLY	48540	See step 7	-	-
8	REAR UPPER CONTROL ARM ASSEMBLY	48790	See step 8	-	-
9	REMOVE REAR SHOCK ABSORBER ASSEMBLY	48540	See step 9	-	-

*A	w/ Stabilizer Bar	-	-
*1	PLATE WASHER	-	-

Fig 3: Rear Shock Absorber Removal Components [03/2023 - ] (3 Of 3)

Callout - Procedure		Part Name Code
10	REAR SHOCK ABSORBER CAP	48554A	See step 10	-	-
11	REAR SUSPENSION SUPPORT ASSEMBLY	48760B	See step 11	-	-

*1	REAR SHOCK ABSORBER ASSEMBLY	-	-
•	Non-reusable part	*	Precoated part