Removal [12/2022 - ]: Procedure

REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY

GTY1159836

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Apply protective tape around the front fender moulding sub-assembly as shown in the illustration.
Remove the 4 clips and 3 screws.

GTY1158101

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Push		Place Hand Here
	Remove in this Direction	-	-

Using a moulding remover, disengage the claw by pushing the area indicated by the arrow in the illustration.
NOTE:
To avoid damaging the claw, do not forcibly pull the front fender moulding sub-assembly.

GTY1154148

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Push		Place Hand Here
	Remove in this Direction	-	-

Disengage the 3 claws by pushing the area indicated by the arrow in the illustration with a finger.
NOTE:
To avoid damaging the claw, do not forcibly pull the front fender moulding sub-assembly.

GTY1142618

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Place Hand Here		Remove in this Direction (1)
	Remove in this Direction (2)	-	-

Disengage the 7 clips as shown in the illustration.
Disengage the clip as shown in the illustration to remove the front fender moulding sub-assembly.
NOTE:
To prevent damage to the clips, make sure to pull the front fender moulding sub-assembly evenly and straight.