Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during back door disassembly/reassembly are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedures	Effect/Inoperative Function When Necessary Procedures are not Performed	Link
Rear television camera assembly*	Parking assist monitor system initialization Rear television camera assembly optical axis (Back camera position setting)	Parking Assist Monitor System	Refer to CALIBRATION [12/2022 - ]
	Rear television camera view adjustment	Parking Support Brake System	Refer to CALIBRATION [12/2022 - ]
		Panoramic View Monitor System	Refer to CALIBRATION [12/2022 - ]
		Advanced Park	Refer to CALIBRATION [12/2022 - ]
Multiplex network door ECU1 Power back door unit assembly set LH Power back door unit assembly set RH*	Reset back door close position	Power Back Door System	Refer to INITIALIZATION [12/2022 - ]
Replacement or removal and installation of 2 or more parts: Front television camera assembly, Radiator grille or Front bumper assembly Rear television camera assembly Side television camera assembly LH, Parking assist light LH or Outer rear view mirror assembly LH Side television camera assembly RH, Parking assist light RH or Outer rear view mirror assembly RH	Television camera view adjustment	Panoramic View Monitor System	Refer to CALIBRATION [12/2022 - ]

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.*1: w/ Power Back Door System

COMPONENTS (DISASSEMBLY)

Fig 1: Back Door Disassembly Components (1 Of 4)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Callout - Procedure		Part Name Code
1	BACK DOOR UPPER TRIM PANEL ASSEMBLY	64790B	-	-	-
2	BACK DOOR SIDE GARNISH LH	67938A	-	-	-
3	BACK DOOR SIDE GARNISH RH	67937B	-	-	-
4	GLIDE DOOR INSIDE HANDLE BASE ASSEMBLY	69290G	See step 4	-	-
5	DOOR PULL HANDLE	74811D	See step 5	-	-
6	BACK DOOR TRIM BOARD ASSEMBLY	67750	-	-	-
7	LUGGAGE COMPARTMENT TRIM COVER	64721K	-	-	-
8	POWER BACK DOOR SENSOR ASSEMBLY LH	84280D	-	-	-
9	POWER BACK DOOR SENSOR ASSEMBLY RH	84270G	-	-	-

w/ Power Back Door

Fig 2: Back Door Disassembly Components (2 Of 4)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Callout - Procedure		Part Name Code
10	MULTIPLEX NETWORK DOOR ECU	89222A	-	-	-
11	POWER BACK DOOR WARNING BUZZER	89747E	-	-	-
12	BACK DOOR LOCK ASSEMBLY WITH COURTESY LIGHT SWITCH	69350P	See step 12	-	-
13	BACK DOOR LOWER STOPPER LH	67282F	-	-	-
14	BACK DOOR LOWER STOPPER RH	67281G	-	-	-

w/ Power Back Door

w/o Power Back Door

Fig 3: Back Door Disassembly Components (3 Of 4)

Callout - Procedure		Part Name Code
15	BACK DOOR OUTSIDE GARNISH LOWER MOULDING LH	76816	-	-	-
16	BACK DOOR OUTSIDE GARNISH LOWER MOULDING RH	76815	-	-	-
17	REAR LIGHT ASSEMBLY	-	See step 17	-	-
18	TELEVISION REAR CAMERA ASSEMBLY	86790D	-	-	-
19	BACK DOOR OPENER SWITCH ASSEMBLY	84840G	-	-	-
20	HOLE PLUG	-	-	-	-

Fig 4: Back Door Disassembly Components (4 Of 4)

Callout - Procedure		Part Name Code
21	DOOR DUST PROOF SEAL	67837L	-	-	-
22	BACK DOOR PANEL CUSHION	67005B	-	-	-
23	BACK DOOR STAY ASSEMBLY LH	68960	See step 23	-	-
24	BACK DOOR STAY ASSEMBLY RH	68950C	See step 24	-	-
25	BACK DOOR DAMPER STAY UPPER BRACKET LH	68946	-	-	-
26	BACK DOOR DAMPER STAY UPPER BRACKET RH	68945	-	-	-
27	BACK DOOR STAY BOLT	68961	-	-	-
28	POWER BACK DOOR UNIT ASSEMBLY LH	68920A	See step 28	-	-
29	POWER BACK DOOR UNIT ASSEMBLY RH	68910B	See step 29	-	-
30	BACK DOOR DAMPER STAY UPPER BRACKET LH	68946	-	-	-
31	BACK DOOR DAMPER STAY UPPER BRACKET RH	68945	-	-	-
32	BACK DOOR DAMPER STAY LOWER BRACKET LH	68948	-	-	-
33	BACK DOOR DAMPER STAY LOWER BRACKET RH	68947	-	-	-

*A	w/o Power Back Door	*B	w/ Power Back Door
•	Non-reusable part	-	-