System is Reset [11/2021 - ]: Procedure

1. Turn the ignition switch to OFF.
2. Check if any external device which emits strong electromagnetic waves and noises, such as a radio antenna, is installed inside the vehicle.

   OK

   External device is not installed.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REMOVE THE EXTERNAL DEVICE 

Result: 

OK 

See step  2

Refer to ON-VEHICLE INSPECTION [11/2021 - ]

Result

Result: 

NG 

CHARGE OR REPLACE THE BATTERY. Refer to  REMOVAL [11/2021 - ] 

Result: 

OK 

See step  3

1. Check the connecting condition of the combination meter assembly connector.

   OK

   The connector is normal.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE THE POOR CONTACT OF CONNECTOR 

Result: 

OK 

See step  4

1. Disconnect the F11 combination meter assembly connector.
2. Measure the voltage according to the value(s) in the table below.

   HINT: 

   Because a temporary open or short circuit may be the cause, shake the harness during this check process.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   F11-1(+B) - Body ground	IG ON	10 to 16 V
   F11-2(IG) - Body ground	IG ON	10 to 16 V

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  5

1. Measure the resistance according to the value(s) in the table below.

   HINT: 

   Because a temporary open or short circuit may be the cause, shake the harness during this check process.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F11-28(GND (S)) - Body ground	Always	Below 1 Ω
   F11-40(GND (P)) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  6

1. Connect the F11 combination meter assembly connector.
2. Turn the ignition switch to ON, and make sure that the combination meter assembly operates properly.

   OK

   The combination meter activate normally.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK 

HINT: 

The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - ]

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [11/2021 - ]