Caution / Notice / Hint
NOTE:
- After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Refer to BEFORE DISCONNECTING BATTERY [09/2022 - ]
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
- After replacing the airbag sensor assembly, refer to work procedure.
Refer to WORK PROCEDURE [11/2022 - 03/2023] , or refer to WORK PROCEDURE [03/2023 - 08/2023] , or refer to WORK PROCEDURE [08/2023 - 09/2024] , or refer to WORK PROCEDURE [09/2024 - ]
- Inspect the fuses for circuits related to this system before performing the following procedure.
- When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
HINT:
When the SRS warning light is illuminated due to a drop in supply power voltage, check the vehicle control history (RoB) before performing an inspection as the airbag sensor assembly stores vehicle control history (RoB) (X210B).