DTC B0097-84: Right Side Restraints Sensor 2 Signal Below Allowable Range [11/2022 - ]: Procedure

Pre-procedure1

1. Turn the ignition switch off.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Side No. 1 Airbag Sensor LH
   *2	Airbag Sensor Assembly
   *3	Wire Harness

2. Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.
3. Interchange the side No. 1 airbag sensor RH with LH and connect the connectors to them.
4. Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.
5. Turn the ignition switch to ON, and wait for at least 60 seconds.

   Procedure1

6. Clear the DTCs stored in memory.

   Body Electrical > SRS Airbag > Clear DTCs 

   Result

   Proceed to
   NEXT

   Post-procedure1

7. Turn the ignition switch off.

Result: 

NEXT 

See step  2

Pre-procedure1

1. Turn the ignition switch to ON, and wait for at least 60 seconds.

   Procedure1

2. Check for DTCs.

   Body Electrical > SRS Airbag > Trouble Codes 

   Result

   Result	Proceed to
   B0097-84 is output	A
   B0092-84 is output	B
   B0092-84 and B0097-84 are not output	C

   HINT: 

   Codes other than DTCs B0092-84 and B0097-84 may be output at this time, but they are not related to this check.

   Post-procedure1

3. Turn the ignition switch off.
4. Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.
5. Return the side No. 1 airbag sensor LH and RH to their original positions and connect the connectors to them.

Result: 

A 

REPLACE AIRBAG SENSOR ASSEMBLY 

Refer to REMOVAL [11/2022 - ]

Result: 

B 

REPLACE SIDE NO. 1 AIRBAG SENSOR RH 

Refer to REMOVAL [11/2022 - ]

Result: 

C 

USE SIMULATION METHOD TO CHECK 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ]