Remove & Install or Remove & Replace
WARNING: This page is about the Sequoia Limited, 4WD, which is a different variant/trim than selected.
DOES NOT include removing Center Support Bearing from Front Shaft.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 4WD, To Front Axle | 1.0 | 0.8 | C | |
| 4WD, To Rear Axle | 1.0 | 0.7 | C | |
| Combination Procedure: DIFFERENTIAL OUTPUT FLANGE: Remove & Replace: | ||||
| 0.4 | B | |||
| Combination Procedure: PROPELLER SHAFT FLANGE: Remove & Replace: | ||||
| Each | 0.3 | B | ||
| Combination Procedure: PROPELLER SHAFT SLIP YOKE: Remove & Replace: | ||||
| 4WD, Front | 0.3 | B | ||
| Combination Procedure: UNIVERSAL JOINT: Remove & Replace: | ||||
| Each | 0.5 | B | ||