Check Bus 4 Line for Short to GND [10/2022 - ]: Description

WARNING: This page is about a different variant/trim than selected.

There may be a short circuit between one of the CAN bus wires and GND when there is no resistance between terminal 22 (CA2H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 7 (CA2L) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3.

Symptom	Trouble Area
There is no resistance between terminal 22 (CA2H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 7 (CA2L) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3.	Short to GND in CAN main bus wire Short to GND in CAN branch wire Central gateway ECU (network gateway ECU) Airbag ECU assembly ECM Steering sensor Rack and pinion power steering gear assembly Brake booster with master cylinder assembly (No. 1 skid control ECU) Brake actuator assembly (No. 2 skid control ECU) Hybrid vehicle control ECU assembly Tire pressure warning ECU and receiver* Occupant detection ECU No. 1 CAN junction connector No. 4 CAN junction connector No. 6 CAN junction connector

Symptom

Trouble Area

There is no resistance between terminal 22 (CA2H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 7 (CA2L) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3.

Short to GND in CAN main bus wire
Short to GND in CAN branch wire
Central gateway ECU (network gateway ECU)
Airbag ECU assembly
ECM
Steering sensor
Rack and pinion power steering gear assembly
Brake booster with master cylinder assembly (No. 1 skid control ECU)
Brake actuator assembly (No. 2 skid control ECU)
Hybrid vehicle control ECU assembly
Tire pressure warning ECU and receiver*
Occupant detection ECU
No. 1 CAN junction connector
No. 4 CAN junction connector
No. 6 CAN junction connector

*: w/ Tire Pressure System (Tire Inflation Pressure Display Function)