Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

WARNING:

When performing the confirmation driving pattern, obey all speed limits and traffic laws.

NOTE:

Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [02/2019 - ]
After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.
DTC check procedure: Turn the ignition switch to ON, turn the blind spot monitor system on using the blind spot monitor main switch (ON/OFF switch), turn the LDA main switch on and wait for approximately 52 seconds or more.
After the repair, perform the CAN bus check and check that all the ECUs and sensors connected to the CAN communication system are displayed as normal.
Refer to DIAGNOSIS SYSTEM [08/2020 - 12/2021]
Some parts must be initialized and set when replacing or removing and installing parts.
Refer to INITIALIZATION [08/2020 - 12/2021]