Installation [06/2020 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL ELECTRIC VEHICLE BATTERY PLUG ASSEMBLY
WARNING:
Be sure to wear insulated gloves and protective goggles.
1. Install the electric vehicle battery plug assembly to the HV battery with the bolt.
  Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf)
2. Connect the hybrid battery terminal block connector.
  NOTE:
  Make sure that the connector is connected securely.
3. Connect the HV battery junction block assembly connector.
  NOTE:
  Make sure that the connector is connected securely.
4. for Type A:
  Engage the 2 claws to close the wiring harness protector.
  
  for Type B:
  
  Engage the claw to close the wiring harness protector.
5. Connect the electric vehicle battery plug assembly connector.
INSTALL NO. 1 HV BATTERY COVER PANEL RH
Refer to PROCEDURE - Step 11
INSTALL REAR SEAT CUSHION LEG SUB-ASSEMBLY
See step 4
INSTALL BATTERY SERVICE COVER BOARD
See step 5
INSTALL NO. 2 BATTERY SERVICE COVER BOARD
See step 6
INSTALL REAR DOOR SCUFF PLATE RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 60 [02/2019 - 08/2020] , or refer to PROCEDURE - Step 58 [08/2020 - 10/2023] , or refer to PROCEDURE - Step 58 [10/2023 - ]
INSTALL NO. 3 BATTERY SERVICE COVER BOARD
See step 8
INSTALL REAR DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 60 [02/2019 - 08/2020] , or refer to PROCEDURE - Step 58 [08/2020 - 10/2023] , or refer to PROCEDURE - Step 58 [10/2023 - ]
INSTALL REAR SEAT CUSHION LOCK HOOK
Refer to PROCEDURE - Step 13
INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY
Refer to PROCEDURE - Step 14
INSTALL SERVICE PLUG GRIP
Refer to INSTALLATION [11/2018 - ]