Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission wire removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Battery terminal is disconnected/reconnected | Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) | Stop and start system | Refer to PRECAUTION [10/2023 - ] |
| Perform steering sensor zero point calibration | Lane control system | Refer to INITIALIZATION [12/2021 - ] | |
| Parking support brake system (for Gasoline model)*1 | |||
| Pre-collision system | |||
| Reset back door close position | Power back door system (for Gasoline model) | Refer to INITIALIZATION [10/2023 - ] | |
| Back door lock initialization*2 | Power door lock control system | Refer to INITIALIZATION [11/2018 - ] |
*1: When performing learning using the Techstream.
*2: w/o Power Back Door System
NOTE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.
WAITING TIME BEFORE DISCONNECTING CABLE FROM NEGATIVE (-) BATTERY TERMINAL
| System Name | See Procedure |
|---|---|
| Vehicle enrolled in Toyota Audio Multimedia system or safety connect system | 6 minutes |
| Vehicle not enrolled in Toyota Audio Multimedia system and safety connect system | 1 minute |