Driver Seat Control ECU Communication Stop Mode [11/2018 - 02/2019]: Description

WARNING: This page is about a different variant/trim than selected.

Detection Item	Symptom	Trouble Area
Driver Seat Control ECU Communication Stop Mode	Any of the following conditions are met: Communication stop for "D-Seat" is indicated on the "Communication Bus Check" screen of the Techstream. Refer to PROBLEM SYMPTOMS TABLE [11/2018 - 02/2019] Communication stop history for "D-Seat" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "D-Seat" is 6 or more.) Refer to PROBLEM SYMPTOMS TABLE [11/2018 - 02/2019] Communication system DTCs (DTCs that start with U) that correspond to "Driver Seat Control ECU Communication Stop Mode" in "DTC Combination Table" are output. Refer to DTC COMBINATION TABLE [11/2018 - 02/2019]	Position control ECU assembly branch wire or connector Power source circuit of position control ECU assembly Position control ECU assembly ground circuit Position control ECU assembly