Check Bus 5 Line for Short to GND [10/2022 - 10/2023]: Description

WARNING: This page is about a different variant/trim than selected.

There may be a short circuit between one of the CAN bus wires and GND when there is no resistance between terminal 15 (CA5H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 16 (CA5L) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3.

Symptom	Trouble Area
There is no resistance between terminal 15 (CA5H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 16 (CA5L) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3.	Short to GND in CAN main bus wire Short to GND in CAN branch wire Central gateway ECU (network gateway ECU) Position control ECU assembly2 Main body ECU (multiplex network body ECU) Certification ECU (smart key ECU assembly)3 Air conditioning amplifier assembly Multiplex network door ECU*1 Combination meter assembly No. 1 CAN junction connector No. 5 CAN junction connector No. 7 CAN junction connector

Symptom

Trouble Area

There is no resistance between terminal 15 (CA5H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 16 (CA5L) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3.

Short to GND in CAN main bus wire
Short to GND in CAN branch wire
Central gateway ECU (network gateway ECU)
Position control ECU assembly*2
Main body ECU (multiplex network body ECU)
Certification ECU (smart key ECU assembly)*3
Air conditioning amplifier assembly
Multiplex network door ECU*1
Combination meter assembly
No. 1 CAN junction connector
No. 5 CAN junction connector
No. 7 CAN junction connector

*1: w/ Power Back Door System

*2: w/ Memory

*3: w/ Smart Key System