Brake Booster (Skid Control ECU) Communication Stop Mode [12/2021 - ]: Description
WARNING: This page is about a different variant/trim than selected.
| Detection Item |
Symptom |
Trouble Area |
| Brake Booster (Skid Control ECU) Communication Stop Mode |
Any of the following conditions are met:
- Communication stop for "Brake Booster" is indicated on the "Communication Bus Check" screen of the Techstream.
Refer to PROBLEM SYMPTOMS TABLE [12/2021 - ]
- Communication stop history for "Brake Booster" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Brake Booster" is 6 or more.)
Refer to PROBLEM SYMPTOMS TABLE [12/2021 - ]
- Communication system DTCs (DTCs that start with U) that correspond to "Brake Booster (Skid Control ECU) Communication Stop Mode" in "DTC Combination Table" are output.
Refer to PROBLEM SYMPTOMS TABLE [12/2021 - ]
|
- Brake booster with master cylinder assembly (No. 1 skid control ECU) branch line or connector
- Power source circuit of brake booster with master cylinder assembly (No. 1 skid control ECU)
- Brake booster with master cylinder assembly (No. 1 skid control ECU) ground circuit
- Brake booster with master cylinder assembly (No. 1 skid control ECU)
|