Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced when repairing air leaks in the intake system are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Air leak from intake system is repaired | Inspection After Repair |
|
Refer to INITIALIZATION [02/2019 - 10/2019]
, or refer to INITIALIZATION [10/2019 - 08/2020]
(w/ Canister Pump Module) Refer to INITIALIZATION [11/2018 - 08/2020] (w/o Canister Pump Module) |