Installation [08/2020 - 12/2021]: Procedure

1. Using an 8 mm socket wrench, install the EGR valve assembly to the EGR valve bracket with the bolt.

   Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

2. Align and fit the hole of the EGR valve bracket to the pin of the camshaft housing.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Pin
   *b	Hole

3. Using the 8 mm socket wrench, install the EGR valve assembly with the EGR valve bracket to the camshaft housing with the bolt.

   Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

4. Connect the No. 4 water by-pass hose to the EGR valve assembly, and slide the clip to secure the hose.
5. Connect the No. 8 water by-pass hose to the EGR valve assembly, and slide the clip to secure the hose.

1. Install a new EGR inlet gasket to the intake manifold.
2. Install a new EGR valve adapter gasket to the No. 1 EGR pipe sub-assembly.
3. Using an 8 mm socket wrench, install the No. 1 EGR pipe sub-assembly to the intake manifold and EGR valve assembly with the 4 bolts.

   Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

1. Install a new EGR valve gasket to the EGR valve assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Claw

   NOTE:

   Make sure that the claws of the EGR valve gasket are toward the EGR valve assembly side.

2. Connect the EGR cooler assembly to the EGR valve assembly with the 2 bolts.

   Torque: 24 N.m (245 kgf/cm, 18 ft.lbf) 

1. Attach the 2 wire harness clamps to connect the engine wire.
2. Install the bolt.

   Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

3. Connect the EGR valve assembly connector.

4. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	No. 1 Fuel Vapor Feed Hose
   *2	No. 2 Fuel Vapor Feed Hose

   Attach the 3 hose clamps to connect the No. 1 fuel vapor feed hose and No. 2 fuel vapor feed hose.

Refer to PROCEDURE - Step 2

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 9