DTC C1626: Steering Angle Sensor Failure [11/2018 - 02/2019]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [11/2018 - 10/2022]

   Chassis > Circumference Monitoring Camera Control Module > Clear DTCs 

2. Check for DTCs.

   Refer to DTC CHECK / CLEAR [11/2018 - 10/2022]

   Chassis > Circumference Monitoring Camera Control Module > Trouble Codes 

   OK

   DTC C1626 is not output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ] 

Result: 

NG 

See step  2

1. Replace the steering sensor with a new or normally functioning one.

   Refer to REMOVAL [11/2018 - 02/2019]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [11/2018 - 10/2022]

   Chassis > Circumference Monitoring Camera Control Module > Clear DTCs 

2. Check for DTCs.

   Refer to DTC CHECK / CLEAR [11/2018 - 10/2022]

   Chassis > Circumference Monitoring Camera Control Module > Trouble Codes 

   OK

   DTC C1626 is not output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (STEERING SENSOR IS DEFECTIVE) 

Result: 

NG 

REPLACE PARKING ASSIST ECU. Refer to  REMOVAL [11/2018 - 10/2022]