LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> RAV4 LE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 173 (Panoramic View Monitor System (HV) - Diagnostic Codes, Circuit Tests & Symptom Tests) >> PANORAMIC VIEW MONITOR SYSTEM (for HV Model) >> DTC C1614: ECU Malfunction [11/2018 - 10/2022] >> Procedure

DTC C1614: ECU Malfunction [11/2018 - 10/2022]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. READ VALUE USING TECHSTREAM (PARKING ASSIST ECU STATUS) 
    1. Use the Data List to check if the parking assist ECU status is functioning properly.

      Refer to DATA LIST / ACTIVE TEST [11/2018 - 12/2021] , or refer to DATA LIST / ACTIVE TEST [12/2021 - 10/2022]

      Chassis > Circumference Monitoring Camera Control Module > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Main CPU Forced Termination Detection Record A history item indicating that the main CPU did not enter standby status within 15 seconds of turning the power switch off and a forced end was applied Unrec/Rec Unrec: Parking assist ECU is normal
      Rec: Parking assist ECU is abnormal
      -
      Main CPU Abnormal Response Record A history item indicating that the main CPU became unresponsive in normal status Unrec/Rec Unrec: Parking assist ECU is normal
      Rec: Parking assist ECU is abnormal
      -
      Main CPU Abnormal Reset Record A history item indicating that the main CPU was reset, although the power switch was not turned off in normal status Unrec/Rec Unrec: Parking assist ECU is normal
      Rec: Parking assist ECU is abnormal
      -
      Image Processing IC Written Protect Record A history item indicating that the image processing IC memory was write protected Unrec/Rec Unrec: Parking assist ECU is normal
      Rec: Parking assist ECU is abnormal
      -
      Image Processing IC Initialized Malfunction Record A history item indicating that the image processing IC memory was not initialized Unrec/Rec Unrec: Parking assist ECU is normal
      Rec: Parking assist ECU is abnormal
      -
      Main EEPROM Access Status Main EEPROM access status OK/NG OK: Parking assist ECU is normal
      NG: Parking assist ECU is abnormal
      -
      Sub EEPROM Access Status Sub-EEPROM access status OK/NG OK: Parking assist ECU is normal
      NG: Parking assist ECU is abnormal
      -
      System Power Supply Voltage Malfunction Record A history item indicating an abnormally generated voltage value from the system power source Unrec/Rec Unrec: Parking assist ECU is normal
      Rec: Parking assist ECU is abnormal
      -
      Main CPU Starting Malfunction Record A history item indicating that the main CPU did not start Unrec/Rec Unrec: Parking assist ECU is normal
      Rec: Parking assist ECU is abnormal
      -
      CAN CPU Boot Malfunction Record A history item indicating that the CPU controlling the input and output of the information obtained via the CAN communication system did not start and the information could not be retrieved Unrec/Rec Unrec: Parking assist ECU is normal
      Rec: Parking assist ECU is abnormal
      -

      Chassis > Circumference Monitoring Camera Control Module > Data List 

      Tester Display
      Main CPU Forced Termination Detection Record
      Main CPU Abnormal Response Record
      Main CPU Abnormal Reset Record
      Image Processing IC Written Protect Record
      Image Processing IC Initialized Malfunction Record
      Main EEPROM Access Status
      Sub EEPROM Access Status
      System Power Supply Voltage Malfunction Record
      Main CPU Starting Malfunction Record
      CAN CPU Boot Malfunction Record

      Result

      Result Proceed to
      OK or Unrec is displayed for all items A
      NG or Rec is displayed B

    Result: 

    USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ] 

    Result: 

    See step  2

  2. CHECK FOR DTC 
    1. Clear the DTCs.

      Refer to DTC CHECK / CLEAR [11/2018 - 10/2022]

      Chassis > Circumference Monitoring Camera Control Module > Clear DTCs 

    2. Check for DTCs.

      Refer to DTC CHECK / CLEAR [11/2018 - 10/2022]

      Chassis > Circumference Monitoring Camera Control Module > Trouble Codes 

      OK

      DTC C1614 is not output.

      Result

      Proceed to
      OK
      NG

      HINT: 

      • If DTC C1614 is output, perform the procedure to allow the parking assist ECU to store the vehicle information again.
      • If DTC C1614 is still output after performing the procedure to make the parking assist ECU store the vehicle information 3 times, replace the parking assist ECU.
      • If DTC C1614 is output frequently, replace the parking assist ECU even though the DTC is not output when rechecking for DTCs.

    Result: 

    OK 

    END 

    Result: 

    NG 

    REPLACE PARKING ASSIST ECU. Refer to  REMOVAL [11/2018 - 10/2022]