Reassembly [11/2018 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL LOWER POSITION INDICATOR HOUSING
- Engage the 4 claws and 2 guides to install the lower position indicator housing to the shift lock control unit assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
NOTE:
Do not damage the lower position indicator housing.
- INSTALL SHIFT POSITION INDICATOR
HINT:
Only perform this procedure when replacement of the shift position indicator is necessary.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
Engage the 2 claws and 3 screws to install the shift position indicator to the upper console panel sub-assembly.
- Engage the clamp to connect the wire harness.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- INSTALL SHIFT LEVER HOLE COVER
- Engage the 2 claws to install the shift lever hole cover to the upper console panel sub-assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|