Components [08/2020 - ]
WARNING: This page is about a different variant/trim than selected.
| Callout | Description | Callout | Description |
| *A | for Type A | *B | for Type B |
| *C | for Short Type | *D | for Long Type |
| *1 | FRONT FENDER APRON SEAL LH | *2 | FRONT FENDER FRONT SPLASH SHIELD LH |
| *3 | FRONT FENDER FRONT SPLASH SHIELD RH | *4 | NO. 1 ENGINE UNDER COVER |
| *5 | NO. 2 ENGINE UNDER COVER ASSEMBLY | - | - |
| *a | Short Type Front Fender Front Splash Shield | *b | Long Type Front Fender Front Splash Shield |
| N.m (kgf/cm, ft.lbf): Specified torque | - | - |
| Callout | Description | Callout | Description |
| *1 | MOTOR COOLING COOLER | *2 | NO. 1 INVERTER COOLING HOSE |
| *3 | NO. 2 MOTOR COOLING PIPE | *4 | NO. 5 INVERTER COOLING HOSE |
| *5 | OIL COOLER UNION BOLT | *6 | NO. 1 MOTOR COOLING HOSE |
| *7 | NO. 2 MOTOR COOLING HOSE | *8 | NO. 1 OIL COOLER TUBE CLAMP |
| *9 | GASKET | - | - |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) | N.m (kgf/cm, ft.lbf): Specified torque | ||
| • | Non-reusable part | - | - |