LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> RAV4 LE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Cooling System (A25A-FXS) - Service Information) >> Thermostat >> Installation [12/2021 - ] >> Procedure

Installation [12/2021 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 
    1. Install a new gasket to the water inlet with thermostat sub-assembly.

      HINT: 

      Be sure to clean the contact surfaces.

    2. Using an 8 mm socket wrench, install the water inlet with thermostat sub-assembly with the 2 bolts.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

    3. Connect the No. 7 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.
      GTY1107015Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a View A *b 15°
      *c 90° *d Upper Side
      *e LH Side *f 1 mm (0.0394 in.) or higher
      NOTE:

      Make sure that the tabs of the clip are within the area shown in the illustration.

  2. CONNECT NO. 2 RADIATOR HOSE 

    Refer to PROCEDURE - Step 47

  3. INSTALL INTAKE MANIFOLD 

    Refer to INSTALLATION [11/2018 - ]

  4. ADD ENGINE COOLANT (for Engine) 

    Refer to PROCEDURE - Step 2

  5. INSPECT FOR COOLANT LEAK (for Engine) 

    Refer to PROCEDURE - Step 1

scientia non olet · About LEMON Manuals