Removal [10/2019 - 08/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE INVERTER WITH CONVERTER ASSEMBLY
- for 2WD
  Refer to REMOVAL [10/2019 - 08/2020]
- for AWD
  Refer to REMOVAL [10/2019 - 06/2020] , or refer to REMOVAL [06/2020 - 08/2020]
DRAIN ENGINE COOLANT (for Engine)
Refer to PROCEDURE - Step 1

REMOVE FLOW SHUTTING VALVE (WATER BY-PASS HOSE ASSEMBLY)

Disconnect the flow shutting valve (water by-pass hose assembly) connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disconnect the outlet heater water hose connector from the No. 2 water by-pass pipe sub-assembly.

NOTE:

Remove any foreign matter on the No. 2 water by-pass pipe sub-assembly and outlet heater water hose connector before performing this work.

Pull out the retainer to detach the lock claws and pull off the outlet heater water hose connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Retainer
	Pull out
	Pull off

Check that there is no foreign matter on the sealing surfaces of the disconnected water lines. Clean them if necessary.
Cover the disconnected No. 2 water by-pass pipe sub-assembly and outlet heater water hose connector with plastic bags to prevent damage and contamination.

Disconnect the inlet heater water hose connector from the flow shutting valve (water by-pass hose assembly).

NOTE:

Remove any foreign matter on the flow shutting valve (water by-pass hose assembly) and inlet heater water hose connector before performing this work.

Pull out the retainer to detach the lock claws and pull off the inlet heater water hose connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Retainer
	Pull out
	Pull off

Check that there is no foreign matter on the sealing surfaces of the disconnected water lines. Clean them if necessary.
Cover the disconnected inlet heater water hose connector with a plastic bag to prevent damage and contamination.

Remove the bolt to disconnect the No. 2 water by-pass pipe sub-assembly.

Remove the bolt to disconnect the flow shutting valve (water by-pass hose assembly).

Slide the clip and disconnect the flow shutting valve (water by-pass hose assembly) from the water by-pass outlet sub-assembly.

HINT:

Use a container to catch any engine coolant which flows out of the flow shutting valve (water by-pass hose assembly) and water by-pass outlet sub-assembly.