Installation [11/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL ENGINE BALANCER ASSEMBLY
Refer to PROCEDURE - Step 6 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 6 [02/2019 - 06/2020] , or refer to PROCEDURE - Step 6 [06/2020 - 08/2020] , or refer to PROCEDURE - Step 6 [08/2020 - 11/2024] , or refer to PROCEDURE - Step 6 [11/2024 - ]
INSTALL STIFFENING CRANKCASE ASSEMBLY
Refer to PROCEDURE - Step 7 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 7 [02/2019 - 06/2020] , or refer to PROCEDURE - Step 7 [06/2020 - 08/2020] , or refer to PROCEDURE - Step 7 [08/2020 - 11/2024] , or refer to PROCEDURE - Step 7 [11/2024 - ]
INSTALL OIL PUMP ASSEMBLY
1. Install the oil pump assembly to the stiffening crankcase assembly with the 3 bolts.
  Torque: 24 N.m (245 kgf/cm, 18 ft.lbf)
INSTALL OIL PUMP BRACKET
Refer to PROCEDURE - Step 9 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 9 [02/2019 - 06/2020] , or refer to PROCEDURE - Step 9 [06/2020 - 08/2020] , or refer to PROCEDURE - Step 9 [08/2020 - 11/2024] , or refer to PROCEDURE - Step 9 [11/2024 - ]
INSTALL ENGINE OIL LEVEL SENSOR
See step 1
INSTALL OIL STRAINER SUB-ASSEMBLY
Refer to PROCEDURE - Step 11 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 11 [02/2019 - 06/2020] , or refer to PROCEDURE - Step 11 [06/2020 - 08/2020] , or refer to PROCEDURE - Step 11 [08/2020 - 11/2024] , or refer to PROCEDURE - Step 11 [11/2024 - ]
INSTALL NO. 2 OIL PAN SUB-ASSEMBLY
Refer to PROCEDURE - Step 12 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 12 [02/2019 - 06/2020] , or refer to PROCEDURE - Step 12 [06/2020 - 08/2020] , or refer to PROCEDURE - Step 12 [08/2020 - 11/2024] , or refer to PROCEDURE - Step 12 [11/2024 - ]
INSTALL TIMING CHAIN COVER ASSEMBLY
Refer to INSTALLATION [11/2018 - 12/2021] , or refer to INSTALLATION [12/2021 - ]