Removal [11/2018 - 02/2019]: Procedure
- PRECAUTION NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Refer to PRECAUTION [11/2018 - ]
- REMOVE DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 2
- REMOVE REAR NO. 2 FLOOR BOARD
Refer to PROCEDURE - Step 3
- REMOVE BATTERY HOLE COVER
Refer to PROCEDURE - Step 4
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [11/2018 - 02/2019]
- REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
Refer to REMOVAL [11/2018 - 02/2019]
- REMOVE FUEL PUMP CONTROL ECU
- Disconnect the 2 connectors from the fuel pump control ECU.
*A for Type A *B for Type B - Remove the 2 bolts and fuel pump control ECU from the body.NOTE:
Do not reuse the fuel pump control ECU if it has been dropped or subjected to a severe impact.
HINT:
If a malfunction such as pump lock occurs and the fuel pump is damaged, excessive current may be continuously applied to the fuel pump control ECU, damaging its internal parts. Make sure to replace the fuel pump control ECU at the same time when replacing the fuel pump.
*A for Type A *B for Type B - Remove the 2 bolts and fuel pump control ECU bracket from the fuel pump control ECU.
*A for Type A *B for Type B
- Disconnect the 2 connectors from the fuel pump control ECU.