Disassembly [11/2018 - 08/2020]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE FUEL SENDER GAUGE ASSEMBLY
See step 7
- REMOVE FUEL PUMP
- Detach the 4 claws and disconnect the sub-assembly support from the fuel sub-tank sub-assembly.
- Disconnect the connector from the fuel pump.
- Detach the 3 claws and remove the No. 1 cap from the sub-assembly support.
- Remove the fuel pump from the sub-assembly support.
- Remove the O-ring from the fuel pump.
- Detach the 4 claws and disconnect the sub-assembly support from the fuel sub-tank sub-assembly.